Поддержи проект - поделись с друзьями!

Просмотрите видео о проекте "Вопрос - ответ"


Добро пожаловать на сайт RusTuts - Вопросы Ответы, где вы можете задавать вопросы и получать ответы от других членов сообщества.

Environmental Test Chambers For Automotive Testing suppliers

0 голосов
Product Introduction
Environmental cycle test chamber for vehicle parts, which is used to test the performance and index of the automobile and components under the conditions of high temperature and low temperature. It is a device that can simulate the absolute and real environment. It is most suitable for automobile manufacturers to be qualified before the automobile delivered out of the factory.
When the summer temperature reaches 40 ℃, the car may cause accidents in the course of driving because the temperature is too high and the parts are not heat-resistant. In the winter of minus 20 ℃, the car is driving on a snowy road. Some automobile parts will greatly reduce their performance because of the low temperature.When temperature reaches 40 ℃ in the summer, the car may cause accidents in the course of driving because the temperature is too high and the parts are not heat-resistant. In the winter of minus 20 ℃, the car is driving on a snowy road, some automobile parts will greatly reduce their performance because of the low temperature.
Application:Environmental cycle test chamber for vehicle parts is used for automotive interior parts test such as IP, DP, Cockpit, CNSL, ashtray, air outlet, etc.
Standards to comply:
Temperature humidity chamber for auto parts should meet below standards:
PR308.2-2006 70℃/95%RH, 105℃ Thermal storage;
IEC 60068-2-1:Basic environmental testing procedures for electronic components and electronic equipment - Part 2: Tests - Test A: Cold
IEC 60068-2-2: Environmental testing - Part 2-2: Tests - Test B: Dry heat
IEC 60068-2-3:Basic environmental testing procedures - Part 2-3: Tests - Test Ca: Damp heat, steady state
IEC 60068-2-28:Basic environmental testing procedures for electronic components and electronic equipment - Part 2: Tests - Guidance for damp heat tests
IEC 60068-2-30:Basic environmental testing procedures - Part 2: Tests - Test Db: Damp heat, cyclic (12+12-hour cycle)
IEC 60068-2-56: Environmental testing - Part 2: Tests. Test Cb: Damp heat, steady state, primarily for equipment.
PV-1200: Environment cycle test for vehicle parts
PV-2005: Environment cycle test for vehicle parts
Graph of Temperature and Humidity Controlled Range Capacity
              
Specification:
Temperature range:  -50°C~120°C
Temperature fluctuation:  ≤ ±2 °C
Temperature deviation:  ≤±0.5 °C
Temperature Uniformity:  ≤2.0 °C
Heat-up time:  ≤ 1 °C/ min
Cool-down time:  0.7°C/ min
Humidity range:  RH 20-90%
Humidity fluctuation: ≤±2.5%
Humidity deviation: ≤±5%
Note:   
Infrared illumination:  Up to 1200w/m2.
When ambient air temperature at 65 ℃, illumination surface temperature could up to be 120 ℃
Temperature humidity chamber for auto parts in customer’s testing lab:
Major users:Environmental Test Chambers For Automotive Testing suppliers
website:http://www.simplewell-intl.com/environmental-test-chambers-for-automotive-testing/
спросил 26 Авг, 19 от xxsxx2v (300 баллов) в категории Электроника

Пожалуйста, войдите или зарегистрируйтесь для публикации ответа на этот вопрос.

Поддержи проект - поделись с друзьями!

...